Colorado 2WD L4-2.8L VIN 8 (2004)
Important: Keep the control valve body level when raising it to the transmission case. This will prevent the loss of checkballs located in the control
valve body passages.
2. Install the control valve body to the transmission case while simultaneously connecting the manual valve link to the manual valve.
3. Verify that the manual valve link (3) is installed properly to the inside detent lever (1) and the manual valve (2).
4. Install one bolt (M6 X 1.0 X 47.5) hand tight in the center of the valve body to hold it in place.
Important: When installing bolts throughout this procedure, be sure to use the correct bolt size and length in the correct location as specified.
5. Do not install the transmission fluid indicator stop bracket and bolt at this time, if equipped
Install but do not tighten the control valve body bolts securing only the valve body directly.
Each numbered bolt location corresponds to a specific bolt size and length, as indicated by the following:
^
M6 X 1.0 X 65.0 (1)