Colorado 2WD L5-3.5L VIN 6 (2005)
Seat Sensor/Switch: Service and Repair
Seat Position Sensor Replacement (Power Seat)
INFLATABLE RESTRAINT SEAT POSITION SENSOR REPLACEMENT (POWER SEAT)
REMOVAL PROCEDURE
1. Remove the seat from the vehicle.
2. Ensure that the seat is in the full rear position.
3. Locate the seat position sensor (1) under the seat on the inside of the inner seat rail.
4. Disconnect the electrical connector (3) from the seat position sensor (1).
5. Remove the 2 nuts (2) that retain the seat position sensor to the seat rail.
6. Remove the seat position sensor from the seat.
INSTALLATION PROCEDURE
1. Install the seat position sensor (1) to the seat rail with 2 nuts (2).
Tighten the seat position sensor nuts to 9 N.m (79 lb in)
NOTE: Refer to Fastener Notice in Service Precautions.
2. Connect the electrical connector (13) to the seat position sensor (1).
3. Install the seat in the vehicle.
