Colorado 2WD V8-5.3L (2009)
7. Disconnect the electrical connector from the window regulator motor, if equipped with A31.
8. Loosen the bolts retaining the window regulator (1) to the inner door at the keyhole slot (2) locations.
9. Remove the bolts retaining the window regulator to the inner panel.
10. Remove the window regulator (1) by lifting the regulator up, and out of the keyhole slots (2) in the inner panel, and removing the regulator out
through the access hole.
Installation Procedure
1. Install the rear door window regulator (1) into the rear door through the access hole.
2. Position the rear door window regulator to the inner panel by inserting the regulator bolts to the keyhole slots (2) on the inner panel.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the bolts retaining the rear door window regulator to the inner panel. Tighten the rear window regulator bolts to 9 Nm (80 lb in).
4. Connect the electrical connector to the window regulator motor, if equipped with A31.
