Colorado 2WD V8-5.3L (2009)
10. Inspect the camshaft position (CMP) sensor O-ring seal (3) for cuts or damage. If the seal is not cut or damaged, it may be used again.
11. Lubricate the O-ring seal with clean engine oil.
12. Install the O-ring seal onto the sensor (2).
13. Install the sensor to the cover.
14. Install the CMP sensor wire harness (5) and bolts (1, 6).
Tighten the bolts to 12 Nm (106 lb in).
15. Connect the engine harness electrical connector (1) to the CMP sensor wire harness electrical connector.
16. Install a NEW crankshaft front oil seal. Refer to Crankshaft Front Oil Seal Replacement (See: Seals and Gaskets/Front Crankshaft Seal/Service
and Repair).
17. Install the water pump. Refer to Water Pump Replacement (With LH8) (See: Water Pump/Service and Repair)Water Pump Replacement (LLV,
LLR) (See: Water Pump/Service and Repair).
