Colorado 2WD V8-5.3L (2009)
5. Connect the engine wiring harness electrical connector (2) to the starter motor.
6. Install the engine wiring harness/positive battery cable terminal (5) to the starter and install the nut (4).
Tighten the nut to 9 Nm (80 lb in).
7. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement (See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings
and Joints/Drive/Propeller Shaft/Service and Repair/Front Propeller Shaft Replacement).
8. Install the right front tire. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
9. Lower the vehicle.
10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Battery/Battery Cable/Service and
Repair).