Colorado 2WD V8-5.3L (2009)
Band Apply Servo: Service and Repair
2-4 Servo (5.3L)
Special Tools
J 29714-A Servo Cover Depressor
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Front Propeller Shaft Replacement).
3. Remove the right catalytic converter. Refer to Catalytic Converter Replacement - Right Side (LH8) (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Right Side).
4. Remove the heat shield bolts (1).
5. Remove the heat shield (2).
6. Clean away all dirt and debris from the 2-4 servo cover area.
7. Remove a single transmission oil pan bolt.
8. Install the J 29714-A in place of the transmission oil pan bolt.
9. Tighten the bolt in order to compress the servo cover.