Colorado 2WD V8-5.3L (2009)
Note: If installing a slip yoke (booted) type seal (34), position the drain hole (1) toward the bottom of the transmission within the area shown
2. Use the J 21426 for a standard seal or J 39440 for a booted type seal with a soft faced mallet to install the seal.
3. Install the seal to the extension housing.
4. Install the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/One-Piece Propeller Shaft Replacement) or Two-Piece Propeller Shaft Replacement (See: Drive/Propeller Shafts,
Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Two-Piece Propeller Shaft Replacement).
5. Remove the drain pan and lower the vehicle.
6. Fill the transmission to the proper level with DEXRON(R) VI transmission fluid. Refer to Transmission Fluid Check (See: Testing and
Inspection/Component Tests and General Diagnostics/Transmission Fluid Check).
