Colorado 2WD V8-5.3L (2009)
2. Install the range selector cable (2) to the range selector cable bracket. Ensure the range selector cable retaining tabs fully engage the range selector
cable bracket.
3. Install the retainer (1) to the range selector cable (2).
4. Connect the range selector cable end (3) to the transaxle range switch lever.
5. Install the heat shield (2).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Install the heat shield bolts (1) and tighten to 10 Nm (89 lb in).
