Colorado 2WD V8-5.3L (2009)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the mounting bracket bolts to the intermediate shaft housing and tighten the bolts to 152 Nm (112 lb ft).
4. Tighten the mounting bracket bolts to 152 Nm (112 lb ft).
5. Remove the support from the front drive axle assembly.
6. Install the wheel drive shaft. Refer to Wheel Drive Shaft Replacement (See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair).
7. Lower the vehicle.