Colorado 2WD V8-5.3L (2009)
9. Remove the mounting bolts for the center bearing.
10. Remove the center bearing from the crossmember.
11. Remove the propeller shaft from the transmission.
Installation Procedure
1. Align the reference marks on the propeller shaft to the transmission.
2. Install the propeller shaft in the transmission.
3. Install the center bearing to the crossmember.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the center bearing mounting bolts and tighten to 80 Nm (59 lb ft).
5. Rotate the propeller shaft so that the alignment marks and the pinion yoke are in alignment.
6. Remove the tape and or rubber band.