Colorado 4WD L4-2.9L (2008)
Tie Rod End: Service and Repair
Rack and Pinion Outer Tie Rod End Replacement
Tools Required
J 24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair) .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
3. Remove the outer tie rod retaining nut. Discard the nut.
Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result
which will cause premature failure of the joint.
4. Disconnect the outer tie rod from the steering knuckle using J 24319-B.
5. Loosen the jam nut and remove the outer tie rod from the inner tie rod. Discard the jam nut.
6. Clean the tapered surface of the steering knuckle.
Installation Procedure
1. Lubricate the inner tie rod threads with a suitable chassis lubricant before installing the outer tie rod .
2. Install the NEW jam nut to the outer tie rod.
3. Install the outer tie rod to the inner tie rod.