Colorado 4WD L5-3.5L VIN 6 (2005)
1. If replacing the bracket, install the bracket to the floor panel.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the 2 fasteners retaining the bracket to the floor panel.
Tighten the fasteners to 9 Nm (80 inch lbs.).
3. Position the TCCM to the bracket.
4. Connect the electrical connectors.
5. Install the TCCM to the bracket, ensuring the retaining tabs (1) are fully engaged.
6. Install the left center pillar.
7. Install the left hinge pillar.
8. Install the left front sill plate.
9. Install the drivers bucket seat or split bench seat.