Colorado 4WD V8-5.3L (2010)
1. If replacing the bracket, install the bracket to the floor panel.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the 2 fasteners retaining the bracket to the floor panel. Tighten the fasteners to 9 Nm (80 lb in).
3. Position the TCCM to the bracket.
4. Connect the electrical connectors.
5. Install the TCCM to the bracket, ensuring the retaining tabs (1) are fully engaged.
6. Install the left center pillar. Refer to Center Pillar Lower Trim Panel Replacement (See: Body and Frame/Interior Moulding / Trim/Trim
Panel/Service and Repair/Center Pillar Lower Trim Panel Replacement).
7. Install the left hinge pillar. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side (See: Body and Frame/Interior Moulding / Trim/Trim
Panel/Service and Repair/Body Hinge Pillar Trim Panel Replacement - Left Side).
8. Install the left front sill plate. Refer to Front Side Door Sill Trim Plate Replacement (See: Body and Frame/Interior Moulding / Trim/Scuff
Plate/Service and Repair/Front Side Door Sill Trim Plate Replacement).
9. Install the drivers bucket seat or split bench seat. Refer to Front Seat Replacement - Bucket (See: Body and Frame/Seats/Service and
Repair/Front Seat Replacement - Bucket) or Split Bench Seat Replacement (See: Body and Frame/Seats/Service and Repair/Split Bench Seat
Replacement).
10. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement and setup information.
