Corsica L4-121 2.0L (1988)
Unlocking Switch Tabs
Fluid Level Sensor Switch
- Remove electrical connector from fluid level sensor switch.
- Remove fluid level sensor switch using needle nose pliers to compress switch locking tabs at inboard side of master cylinder.
Removing/Installing Reservoir Spring Pins
NOTE: In order to remove the proportioner valve caps it may be necessary to remove the reservoir assembly.
Reservoir Assembly
- Clamp flange on master cylinder in a vise, then drive out spring pins using 1/8 inch punch.
- Remove reservoir by pulling straight up, away from cylinder body. Remove O-rings.
- Inspect reservoir for cracks or deformation and replace if found.
Proportioner Valve Cap Assemblies