Corsica L4-121 2.0L (1988)
FIGURE 5 - TORQUING NUT
2.
Remove pivot prevention pin from wiper arm.
3.
Install new nut (PN 20604449) with torque wrench (Figure 5). Torque MUST BE 20-24 N-m.
FIGURE 6 - BLADE WIPE PATTERN CHECK
4.
Run wiper system and check for correct wipe pattern. L.H. blade tip should wipe to a limit of 1-1.5
inches (25-38 mm) from outside edge of glass. R.H. blade should overlap into L.H. wipe pattern as
shown on Figure 6.
FIGURE 1 - HOSE, CAP AND NUT REMOVAL
5.
Connect washer hose (Figure 1).
6.
Install protective cap. (Figure 1).