Corsica V6-3100 Power Steering System Service - Steering Gear - Service and Repair
Fig. 25 Outer Tie Rod Assembly
1. Remove cotter pin, then hex slotted nut from outer tie rod ball stud, Figs. 24 and 25.
2. Loosen outer tie rod pinch bolts, then separate outer tie rod from steering knuckle using steering linkage puller, tool No. J 24319-01, or equivalent.
3. Remove outer tie rod from tie rod adjuster.
4. Reverse procedure to install, noting the following:
a. Torque hex slotted nut to 35 ft. lbs., with a maximum of 50 ft. lbs. to install cotter pin.
b. Adjust toe by turning tie rod adjuster.
c. Torque pinch bolts to 41 ft. lbs.
Inner Tie Rod