Corvette V8-350 5.7L (1982)
Neutral Safety Switch: Service and Repair
1982 CORVETTE
1.
Disconnect shift control lever arm from transmission control rod.
2.
Remove shift control knob.
3.
Remove trim plate.
4.
Remove control assembly from seal and disconnect switch wiring.
5.
Remove switch from control assembly.
6.
To install, position gearshift in Drive position, align hole in contact support with hole in switch and insert a pin (3/32 inch) to hold support in
place.
7.
Place contact support drive slot over drive tang and tighten switch mounting screws.
8.
Connect wiring harness to switch wiring.
9.
Install trim plate control knob and connect shift lever arm to transmission control rod.
