Corvette V8-6.2L (2008)
3. Position the intermediate pipe on the jack stands.
4. Raise the intermediate pipe and install the intermediate pipe.
5. Install the exhaust pipe seal.
6. Install the intermediate pipe (2) to the exhaust mufflers (1).
Important: When install the retaining nuts, hand tighten them. This will allow the proper alignment of the exhaust system for the final
assembly procedure.
7. Install the retaining nuts (2).
8. Remove the adjustable jack stands.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
9. Tighten the exhaust muffler clamps (2) and (5).
Tighten the exhaust clamps bolts to 44 N.m (32 lb ft).
10. Tighten the intermediate pipe to catalytic converter pipe nuts and bolts.
Tighten the intermediate pipe-to-catalytic converter pipe nuts and bolts to 25 N.m (18 lb ft).
