Corvette V8-6.2L (2008)
be used instead. When using the J 45096 , monitor the display panel to determine the amount of fluid being pumped from the tool supply tank into
the transmission.
4. Using the DT 47784 (1), J 45096-30 (2), and the J 45096 (3), add transmission fluid through the check plug hole. Refer to Transmission Fluid
Cooler Flushing and Flow Test (J 45096) (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and
Inspection/Component Tests and General Diagnostics/Transmission Fluid Cooler Flushing and Flow Test (J 45096)) for complete J 45096
operating instructions. Use the FLOW position on the main function switch to pump the fluid.
Important: Failure to start the engine and move the shift lever through the gear ranges before removing the DT 47784 and J 45096-30
from the bottom pan will result in an excess amount of fluid draining from the check plug hole. This may lead to an under-fill condition.
5. Start the engine and move the shift lever through each gear range. Pause for at least 3 seconds in each gear range.
6. With the engine still running, remove the DT 47784 (1), J 45096-30 (2), and J 45096 (3) and then check the fluid level. Refer to Transmission
Fluid Check (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General
Diagnostics/Transmission Fluid Check) .
