Corvette V8-6.2L (2008)
Important:
*
The service jack lift pad must not come in contact with the rear suspension monoleaf spring.
*
Carefully observe the following:
-
Be sure to place a block or pad between the jack lift pad and the vehicle.
-
Make sure the jack lift pad spans at least 2 suspension crossmember ribs (1).
-
Lift only in the areas shown.
Position the service jack lift pad as follows:
Spanning the 2 suspension crossmember ribs (1).
Supporting the Vehicle with Jack Stands
Important: Do not place jack stands under the frame rails.
Under the Front Suspension Crossmember - Preferred Front Location
Important:
*
The jack stand support pads must not come in contact with the engine oil pan (2) or the front suspension monoleaf spring.
*
Carefully observe the following:
-
Be sure to place a block or pad between the jack stand support pads and the vehicle.
-
Make sure the jack stand support pads span at least 2 suspension crossmember ribs (1).
-
Support only in the areas shown.
Position the jack stand support pads as follows:
*
In the preferred location (3) if possible, spanning at least 2 of the suspension crossmember ribs (1).
*
In the optional location (4) if necessary, spanning at least 2 of the suspension crossmember ribs (1).
Under the Front Suspension Crossmember - Optional Front Location