Workshop Repair Manuals

Chevrolet Workshop Manuals

[PREV PAGE] [NEXT PAGE]

chevrolet Workshop Repair Guides


Corvette V8-6.2L (2008)

Powertrain Management > Computers and Control Systems > Oxygen Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 4015

Page 8
background image

Backprobe

Important:  

*

Backprobe connector terminals only when specifically required in diagnostic procedures.

*

Do not backprobe a sealed (Weather Pack(R)) connector, less than a 280 series Metri-Pack connector, a Micro-Pack connector, or a flat
wire (dock and lock) connector.

*

Backprobing can be a source of damage to connector terminals. Use care in order to avoid deforming the terminal, either by forcing the
test probe too far into the cavity or by using too large of a test probe.

*

After backprobing any connector, inspect for terminal damage. If terminal damage is suspected, test for proper terminal contact.

Do not disconnect the connector and probe the terminals from the harness side (back) of the connector.

Scan Tool Snapshot Procedure

Scan Tool Snapshot Procedure

Powertrain Management > Computers and Control Systems > Oxygen Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 4015

[PREV PAGE] [NEXT PAGE]