Workshop Repair Manuals

Chevrolet Workshop Manuals

[PREV PAGE] [NEXT PAGE]

chevrolet Workshop Repair Guides


Corvette V8-6.2L (2008)

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 4251

Page 94
background image

8. Center the crimp tool over the splice clip and wires.
9. Apply steady pressure until the crimp tool closes.

Ensure that no strands of wire are cut.

10. Crimp the splice on each end (2).

11. Apply 60/40 rosin core solder to the opening in the back of the clip. Follow the manufacturer's instructions for the solder equipment.

12. Tape the splice. Roll on enough tape in order to duplicate the thickness of the insulation on the existing wires.

13. Additional tape can be applied to the wire if the wire does not belong in a conduit or another harness covering. Use a winding motion in order to

cover the first piece of tape.

Splicing Copper Wire Using Splice Sleeves

Splicing Copper Wire Using Splice Sleeves

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 4251

[PREV PAGE] [NEXT PAGE]