Corvette V8-6.2L (2008)
Fuel Line Coupler: Service and Repair
Metal Collar Quick Connect Fitting Service
Metal Collar Quick Connect Fitting Service
Special Tools
J 37088-A Fuel Line Disconnect Tool Set
Removal Procedure
1. Relieve the fuel system pressure before servicing any fuel system connection. Refer to the Fuel Pressure Relief (With CH 48027) (See: Fuel
Filter/Fuel Pressure Release/Service and Repair/Fuel Pressure Relief (With CH 48027))Fuel Pressure Relief (Without CH 48027) (See: Fuel
Filter/Fuel Pressure Release/Service and Repair/Fuel Pressure Relief (Without CH 48027)) .
2. Slide the dust cover from the quick connect fitting.
Caution: Wear safety glasses when using compressed air in order to prevent eye injury.
3. Blow any dirt out of the fitting, using compressed air.
4. Choose the correct tool from the J 37088-A Tool Set for the size of the fitting. Insert the tool into the female connector, then push inward in order
to release the locking tabs.
5. Pull the connection apart.
Notice: If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent
damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs.
Clean or replace the components and assemblies as required.
