Chevrolet Workshop Manuals
Corvette V8-6.2L (2008)
Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Body Control Module Replacement > Page 2771
Notice: To prevent possible electrostatic discharge damage to the BCM, do not touch the connector pins or soldered components on the circuit
Notice: To prevent internal BCM damage, the ignition must be OFF when disconnecting or reconnecting power to BCM (for example, battery
Notice: The BCM electrical connectors are designed with tabs and slots that allow the connectors to only fit one way. The connectors do not
1. Turn OFF the ignition switch.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Install 3 retaining screws (1) to the BCM (2).
Tighten the screws to 2 N.m (18 lb in).
5. Install the kick-up panel. Refer to Front Floor Kick-Up Panel Replacement (See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service
and Repair) .
6. If you are installing a new or replacement BCM, program the BCM to the current vehicle. Refer to Control Module References (See: Testing and
Inspection/Programming and Relearning) .
|[PREV PAGE] [NEXT PAGE]|