Workshop Repair Manuals

Chevrolet Workshop Manuals

[PREV PAGE] [NEXT PAGE]

chevrolet Workshop Repair Guides


Corvette V8-6.2L (2008)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 297

Page 23
background image

6. Use the J 38125-213 or the J 38125-556 (GM P/N 12093647) tool to release the terminals by inserting the tool into the terminal release cavity. See

the release tool cross reference in the Reference Guide of the J-38125  to ensure that the correct release tool is used.

7. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a

terminal out of a connector.

Repair Procedure

Important:  Ensure that the dress cover and connector body are both in the released position before reassembling. Failure to do so may cause
damage to the connector and component.

Use the appropriate terminal and follow the instructions in the J-38125  . 

Location of the terminal in the repair tray and the proper crimp tool can be found in the appropriate connector end view.

Bosch Connectors (0.64)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 297

[PREV PAGE] [NEXT PAGE]