Workshop Repair Manuals

Chevrolet Workshop Manuals

[PREV PAGE] [NEXT PAGE]

chevrolet Workshop Repair Guides


Corvette V8-6.2L (2008)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Oxygen Sensor > Component Information > Service and Repair > Heated Oxygen Sensor Replacement - Bank 1 Sensor 1 > Page 941

Page 2
background image

1. Coat the threads of the oxygen sensor 2 with the anti-seize compound P/N 5613695, or the equivalent if necessary.

Notice:  Refer to Fastener Notice  (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .

2. Install the bank 2, oxygen sensor 2 (4), in the catalytic converter.

Tighten the bank 2, oxygen sensor 2 to 41 N.m (30 lb ft).

3. Reconnect the bank 2, oxygen sensor 2 (4), electrical connector to the engine wiring harness electrical connector.
4. Lower the vehicle.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Oxygen Sensor > Component Information > Service and Repair > Heated Oxygen Sensor Replacement - Bank 1 Sensor 1 > Page 941

[PREV PAGE] [NEXT PAGE]