Workshop Repair Manuals

Chevrolet Workshop Manuals

[PREV PAGE] [NEXT PAGE]

chevrolet Workshop Repair Guides


Corvette V8-6.2L (2008)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Vehicle Speed Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 1052

Page 89
background image

11. Using the heat torch, apply heat to the crimped area of the barrel.
12. Gradually move the heat barrel to the open end of the tubing:

*

The tubing will shrink completely as the heat is moved along the insulation.

*

A small amount of sealant will come out of the end of the tubing when sufficient shrinkage is achieved.

13. Center the high temperature SCT1 shrink tube over the DuraSeal splice sleeve.
14. Using the heat torch, apply heat to the high temperature heat shrink tubing.
15. Gradually move the heat from the center to the open end of the tubing:

*

The tubing will shrink completely as the heat is moved along the insulation.

*

A small amount of sealant will come out of the end of the tubing when sufficient shrinkage is achieved.

16. Replace any reflective tape and clips that may have been remove during the repair. 

Repairing Damaged Wire Insulation

Repairing Damaged Wire Insulation

If the conductive portion of the wire is not damaged, locate the problem and apply tape around the wire. If the damage is more extensive, replace the
faulty segment of the wire. Refer to Splicing Copper Wire Using Splice Clips (See: Testing and Inspection/Component Tests and General Diagnostics)
and follow the instruction to repair the wire.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Vehicle Speed Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 1052

[PREV PAGE] [NEXT PAGE]