Corvette V8-6.2L (2008)
Ride Height Sensor: Service and Repair
Electronic Suspension Front Position Sensor Replacement
Electronic Suspension Front Position Sensor Replacement
Removal Procedure
1. Turn OFF the ignition switch.
2. Raise the vehicle on a suitable safety stand. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Service Intervals) .
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair)
.
4. Disconnect the position sensor connector (3).
5. Remove the position sensor harness retainers.
6. Remove the position sensor link from the control arm link stud (2).
7. Remove the position sensor mounting bolts (4).
8. Remove the position sensor (1) from the vehicle.
Installation Procedure
1. Install the position sensor (1) in the vehicle.
Notice: Refer to Fastener Notice .
2. Install the position sensor mounting bolts (4).
Tighten the bolts to 3 N.m (26 lb in).
3. Install the position sensor link to the control arm link stud (2).
4. Connect the position sensor electrical connector (3).
5. Secure the position sensor harness with the retainers.
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .
7. Lower the vehicle.