Corvette V8-6.2L SC (2009)
2. Install the piston (1), the dust seal (2), and the piston seal (3) in the brake caliper piston bore.
Note: When the brake caliper piston dust seal is properly installed, the seal may protrude slightly above the surface of the brake caliper. This is a
normal condition due to the slight curvature of the brake caliper.
3. Using the CH-47954 - Caliper Seal Installer , install the dust seal:
1. Position the C-Clamp and cup on the caliper.
2. Align the tool on the dust seal to ensure correct installation of the dust seal.
3. Using the C-clamp, slowly apply pressure to the dust seal.
4. Check the alignment of the dust seal to the brake caliper bore.
5. If the position of the tool and dust seal has changed, reposition the tool on seal.
6. Fully seat the dust seal in the piston bore.
7. Repeat the above procedure for the remaining dust seals.
4. Remove the brake caliper from the vise.
