Corvette V8-6.2L SC (2009)
Telescoping Wheel Switch: Service and Repair
Telescope Actuator Switch Replacement
Removal Procedure
Warning: Refer to SIR Warning (See: Restraint Systems/Service Precautions/SIR Warning).
1. Disable the SIR system. Refer to SIR Disabling and Enabling (See: Steering/Steering Column/Air Bag(s) Arming and Disarming/Service and
Repair).
2. With the column fully extended remove the key from the ignition.
3. Remove the tilt lever from the steering column. Refer to Tilt Lever Replacement (See: Steering/Steering Column/Service and Repair/Tilt Lever
Replacement).
4. Remove the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair).
5. Remove the 2 TORX(R) head screws from the lower trim cover.
6. Separate the retaining tabs on the lower trim cover from the steering column close out trim cover.
7. Remove the switch wires from the telescope motor assembly, which is routed in clips along the bottom of the lower trim cover.
8. From the inside of the lower trim cover, push out the telescope actuator assembly switch.
9. Disconnect the assembly switch connector from the instrument panel wiring harness.
10. Remove the telescope motor assembly switch and wires from the trim cover.
Installation Procedure
1. Install the telescope motor assembly switch and wires through the opening in the lower trim cover.