chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Antitheft and Alarm Systems > < Digital Radio Antenna Cable Replacement (Convertible)|Page 16064
Page 3
background image

3. Push the new connector at the left side of the I/P through the plastic seal at the left side pillar to door pass-through, reconnect the connector, and

reinstall the plastic seal. The seal should snap into place securely. Use tie straps as needed to secure the new antenna cable under the left side of
the I/P.

4. Route the new cable alongside the old cable as closely as possible following left side of the vehicle to the digital receiver. Reconnect to the

receiver. Use tie straps as needed to secure the new cable.

5. Install the right front carpet retainer.
6. Install the right I/P closeout panel.
7. Install the left I/P closeout panel.
8. Install the left lock pillar trim.
9. Install the left front carpet retainer.

10. Install the left side door mechanical release lever.
11. Install the rear compartment carpet.

Antitheft and Alarm Systems > < Digital Radio Antenna Cable Replacement (Convertible)|Page 16064