Corvette V8-7.0L (2007)
Rear Bumper Reinforcement: Service and Repair
Impact Bar Replacement - Rear Bumper (Z06)
Impact Bar Replacement - Rear Bumper (Z06)
Tools Required
J 42058 Frame Adapter Clamp
Removal Procedure
Caution: Refer to Approved Equipment for Collision Repair Caution .
1. Disable the SIR system. Refer to SIR Disabling and Enabling .
2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (6.0L) Battery Negative Cable
Disconnection and Connection (7.0L) .
3. Remove all related panels and components.
4. Repair as much of the damage as possible to the factory specifications.
5. Use J 42058 to secure the vehicle if pulling and straightening are required.
6. Note the location and remove the sealers and anti-corrosion materials from the repair area. Refer to Anti-Corrosion Treatment and Repair .
Important:
*
Hand tools, saw blades and abrasives used for aluminum repairs should be dedicated for aluminum only to prevent contamination.
*
When removing welds, favor the bumper bar side of the weld joint.
Locate and remove all factory welds (1) attaching the rear bumper bar to the bottom of the rear frame rails. Note the location of the welds for
installation of the new bumper bar.
