Corvette V8-7.0L (2007)
14. Using a P-MIG welder, weld (1) the battery tray to the battery tray bracket.
Important: DO NOT top coat the bonding surface of the rear bar. Use primer only on bonding surfaces. Refer to adhesive
manufacturer's recommendations.
15. Clean and prepare all bonding mating surfaces according to adhesive manufacturer's recommendations.
16. Apply a consistent bead of structural adhesive to the top impact bar to bond to the rear compartment panel. Refer to Sheet Molded Compound
(SMC) Panel Bonding .
17. Apply the sealers and anti-corrosion materials to the repair area. Refer to Anti-Corrosion Treatment and Repair .
18. Paint the repair area. Refer to Basecoat/Clearcoat Paint Systems .
19. Install all related panels and components.
20. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (6.0L) Battery Negative Cable Disconnection
and Connection (7.0L) .
21. Enable the SIR system. Refer to SIR Disabling and Enabling .
