Corvette V8-7.0L (2007)
Installation Procedure
Caution: Refer to Express Down Feature Caution.
1. Adjust the regulator jack screws to match the old regulator if replacing the regulator.
2. Fold the regulator and insert the folded regulator into the door with the motor forward.
3. Position the motor studs through the door inner panel.
Notice: Refer to Fastener Notice.
4. Install the nuts to the motor studs.
Tighten the window regulator motor nuts to 10 N.m (89 lb in).
5. Install the regulator channel studs through the holes in the door.
6. Install the nuts to the regulator channel studs in the following order:
1. Upper forward
2. Lower forward
3. Upper rearward
4. Lower rearward
7. Install the regulator rose bud clip to the door.
8. Tighten the window regulator channel stud nuts.