Corvette V8-7.0L (2007)
Convertible Top Weatherstrip: Service and Repair
Weatherstrip Side Retainer Replacement (Coupe and Convertible)
Removal Procedure
1. Remove the windshield weatherstrip from the weatherstrip side retainer and partially from the windshield frame. Refer to Weatherstrip
Replacement (Coupe and Convertible) Weatherstrip Replacement (Hardtop) .
2. Remove the weatherstrip side retainer screws from the side reveal molding and the applique.
3. Remove the retainer. If the retainer is to be reused, remove the old foam sealing tape from the retainer.
4. Remove any old foam sealing tape from the retainer mounting surfaces.
Installation Procedure
1. Replace the foam tape if reusing the retainer:
*
Extend the tape 2.0 mm (0.08 in) beyond the retainer ends.
*
Do not stretch the tape to fit. The tape may shrink back, or creep, after installation, resulting in a gap which may cause a leak.
2. Peel the protective cover from the foam tape.
3. Replace any stripped, broken or improperly seated screws.
Notice: Refer to Fastener Notice .
