Corvette V8-7.0L (2007)
8. Remove and discard the two copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end.
9. Plug the opening in the brake caliper and the brake hose to prevent fluid loss and contamination.
10. Remove the brake caliper guide pin bolts.
11. Remove the brake caliper from the caliper mounting bracket.
Installation Procedure
1. Inspect the caliper slide boots for cuts, tears, or deterioration. If damaged, replace the slides and the boots.
2. Install the brake caliper to the caliper mounting bracket.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the brake caliper guide pin bolts.
Tighten the brake caliper guide pin bolts to 31 N.m (23 lb ft).
4. Remove the plug from the brake caliper opening and the brake hose.
Important: Install NEW copper brake hose gaskets.
5. Assemble the NEW copper brake hose gaskets, and the brake caliper inlet fitting bolt to the brake hose.
6. Install the brake hose and the brake caliper inlet fitting bolt to the brake caliper.
Tighten the brake caliper inlet fitting bolt to 45 N.m (33 lb ft).
