Corvette V8-7.0L (2007)
Important: When the dust seal is seated, the dust seal maybe slightly above the surface of the caliper, this is normal. The inner surface of
the caliper is slightly curved.
5. Using the CH-47954, install the dust seal in the following manner:
1. Position the C-Clamp and cup on the caliper.
2. Align the tool on the dust seal for the proper installation of the dust seal.
3. Slowly apply pressure to the dust seal.
4. Check the alignment of the dust seal to the bore.
5. If the position of the tool and dust seal has changed, reposition the tool on seal.
6. Fully seat the dust seal in the piston bore.
7. Repeat this procedure for the rest of the pistons that need to be serviced.
6. Remove the brake caliper from the vise.
Important: In the following service procedure, use caution as not to damage the dust seal.
7. Using a small flat-bladed pocket screwdriver, install the dust seal in the groove in the piston.
8. Install the brake caliper.
9. Replace the brake pads if needed.
Front Brake Caliper Overhaul (JL9-J55)
Front Brake Caliper Overhaul (JL9-J55)
Caution: Refer to Brake Fluid Irritant Caution.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice.
