Corvette V8-7.0L (2007)
5. Connect the electrical connector to the EBCM (3). Ensure the cam (2) is secured by the lock tab.
6. Connect the electrical connector to the brake fluid pressure sensor.
7. Install the two BPMV bracket-to-crossmember mounting bolts.
Tighten the bolts to 27 N.m (20 lb ft).
8. Lower the vehicle.
9. Connect the negative battery cable.
10. If installing a replacement module, refer to Service Programming System (SPS).
11. If installing a replacement module, program the replacement module. Refer to Programming and RelearningSee: Testing and
Inspection/Programming and Relearning
