Corvette V8-7.0L (2007)
1. Install new engine oil cooler hose/pipe seals.
2. Install the external engine oil cooler.
Notice: Refer to Fastener Notice.
3. Install the external engine oil cooler retaining bolts.
Tighten the bolts to 10 N.m (89 lb in).
4. Remove the oil drain pan from under the vehicle.
Important: The quick connect fitting must be pushed on and then pulled back to verify proper connector engagement.
5. Install the engine oil cooler hose/pipes to the external oil cooler.
6. Install the left wheelhouse extension.
7. Install the left fender liner.
8. Refill the engine with oil and check for leaks.
