Corvette V8-7.0L (2007)
3. Align the oil pump surfaces (1) with the engine block surfaces (2). The oil pump must be aligned flush or no greater than 0.1 mm (0.04) below
the engine block pan rail.
Notice: Refer to Fastener Notice.
4. Install the J 41480 and bolts to the engine block.
Tighten the J 41480 bolts to 25 N.m (18 lb ft).
5. Firmly push the oil pump until the pump surfaces contact the J 41480. While holding the oil pump to the J 41480, tighten the oil pump bolts.
Tighten the oil pump bolts to 25 N.m (18 lb ft).
