Corvette V8-7.0L (2007)
39. Remove and discard the air inlet, drain and plumbing seals from the HVAC module.
Installation Procedure
1. If a new HVAC module is being installed, add the specified amount of PAG oil to the evaporator core. Refer to Refrigerant System Capacities.
Notice: Refer to Fastener Notice.
2. Install the HVAC module studs.
Tighten the studs to 4 N.m (35 lb in).
3. Install new air inlet, drain and plumbing seals to the HVAC module.
Important: Ensure that the cut-outs on the dash-mat are properly aligned so that the drain and plumbing seals are seated directly
against the cowl and the air inlet seal is seated directly against the dash-mat.
