Corvette V8-7.0L (2007)
12. Remove the wheel hub mounting bolts.
13. Remove the hub and bearing assembly from the suspension knuckle.
Installation Procedure
Notice: The Front and Rear Wheel Hub/Wheel Speed Sensors are not interchangeable. When you are replacing a Wheel Hub/Wheel Speed Sensor
be sure to use the correct Wheel Hub/Wheel Speed Sensor part number. Do not mount the Rear Wheel Hub/Wheel Speed Sensor in the front
steering knuckle. The Rear Wheel Hub/Wheel Speed Sensor features a splined hole through the center of the bearing which mates to the drive
axle. The Rear Wheel Hub/Wheel Speed Sensor requires the support of the drive axle and the drive axle nut clamped joint to properly carry the
vehicle loads. Mounting the Rear Wheel Hub/Wheel Speed Sensor in the front steering knuckle can cause bearing failure and possible damage to
the vehicle.
Notice: Refer to Fastener Notice.
1. Install the wheel hub and bearing assembly to the suspension knuckle.
Tighten the wheel hub mounting bolts to 130 N.m (96 lb ft).
2. Install the suspension knuckle to the upper control arm (1).
3. Install the suspension knuckle (2) to the lower control arm ball stud.
4. Install the spindle nut, washer and retainer.
5. Install the outer tie rod end stud to the suspension knuckle.
6. Install the brake rotor and caliper.
7. Connect the wheel speed sensor harness connector.
