Corvette V8-7.0L (2007)
Information Bus: Scan Tool Testing and Procedures
Scan Tool Data Definitions
Scan Tool Data Definitions
Accy. Indicator Command
-
The scan tool displays the status of the accessory indicator.
Accy. Relay Command
-
The scan tool displays the status of the accessory output.
Auxiliary Power
-
The scan tool displays the status of the auxiliary power relay.
Battery Voltage Signal
-
The scan tool displays 0.0-16.0 volts. The battery voltage input represents the system voltage measured at the module ignition feed input.
Brake Apply Sensor Reference Signal
-
The scan tool displays the voltage read by the brake apply sensor.
Current Power Mode
-
The scan tool displays the current power mode.
Idle Boost Level
-
The scan tool displays the level of the idle boost.
Ignition Cycle Counter
-
The scan tool displays the ignition cycle counter.
Ignition Mode Switch
-
The scan tool displays the voltage and the state read by the module from the ignition mode switch.
Ign. Mode Sw. Dimming Command
-
The scan tool displays the status of the ignition mode switch dimming.
Inadvertent Power Cmd.
-
The scan tool indicates the status of the inadvertent power command.
Inadvertent Power Signal
-
The scan tool displays the status of the inadvertent power signal.
Key in Cylinder Switch
-
The scan tool displays if the key is in the trunk cylinder switch.
Off Indicator Command
-
The scan tool displays the status of the off indicator.
Run/Crank Relay Command
-
The scan tool displays if the run/crank relay is controlled or not by the module.
Start Indicator Command
-
The scan tool displays the status of the start indicator.
Scan Tool Data List
Scan Tool Data List
