Corvette V8-7.0L (2007)
Seat Belt Tensioner: Removal and Replacement
Seat Belt Buckle Pretensioner Replacement
Removal Procedure
Caution: When carrying an undeployed inflatable restraint seat belt pretensioner:
*
Do not carry the seat belt pretensioner by the wires or connector.
*
Carry the seat belt pretensioner by the piston tube, keeping hands and fingers away from the cable.
*
Make sure the open end of the seat belt pretensioner piston tube points away from you and other people.
*
Do not cover the seat belt pretensioner piston tube opening with your hand.
Failure to observe these guidelines may result in personal injury.
Caution: Refer to Restraint System Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Disconnect the pretensioner electrical connector from the side air bag connector.
3. Remove the seat from the vehicle.
4. Remove the pretensioner fastener (2) and remove the pretensioner (1) from the seat.
5. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Pretensioner Handling and Scrapping.
Installation Procedure
1. Install the pretensioner (1) to the seat. Notice that the pretensioner has a tab that fits into the seat in order to insure that the pretensioner is in the
proper position.
Notice: Refer to Fastener Notice.
2. Install the fastener (2) while holding the pretensioner in place.
Tighten the nut to 42 N.m (31 lb ft).
3. Install the seat into the vehicle.
