Corvette V8-7.0L (2007)
1. Install the suspension knuckle to the lower control arm ball joint stud.
2. Install the suspension knuckle ball joint stud to the upper control arm.
3. Install the spindle nut, washer and retainer.
4. Install the outer tie rod end to the suspension knuckle.
5. Install the brake rotor and caliper.
6. Connect the wheel speed sensor harness connector.
7. Connect the ESC position sensor link.
8. Install the tire and wheel assembly.
9. Lower the vehicle.
10. Perform a rear wheel alignment. Refer to Measuring Wheel Alignment.
