Corvette V8-7.0L (2007)
1. Install steering knuckle to the upper control arm and the lower control arm.
2. Remove the jackstand.
3. Install the steering linkage outer tie rod ball stud to the steering knuckle.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the stabilizer shaft link to the lower control arm.
Tighten the stabilizer shaft link nut to 72 N.m (53 lb ft).
5. Connect the wheel speed sensor electrical connector.
6. Install the brake rotor and caliper.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
9. Check the front wheel toe and adjust as necessary. Refer to Diagnostic Starting Point - Disc Brakes See: Brakes and Traction Control/Disc Brake
System/Testing and Inspection/Initial Inspection and Diagnostic Overview Refer to Measuring Wheel Alignment.
