Corvette V8-7.0L (2007)
Steering Column Lock: Service and Repair
Steering Wheel Theft Deterrent Lock Replacement (Manual)
Steering Wheel Theft Deterrent Lock Replacement (Manual)
Tools Required
J 42640 Steering Column Lock Pin
Removal Procedure
Caution: Refer to Restraint System Service Precautions.
1. Disable the SIR system.
Important: If the steering column connectors are disconnected with the ignition in the ON position, the BCM will enter a fail enable mode
and prevent steering column lock operation. The PCM will also inhibit vehicle motion by disabling fuel. To clear the BCM fail enable
mode, disconnect the BCM fuse #25 for 15 seconds.
2. Remove the trim covers from the upper and lower steering column.
3. Remove the wire harness straps (2) from the steering column tilt head assembly (1) and the column.
4. Install J 42640 to the steering column.
5. Remove the steering column tilt head assembly.
6. Remove the steering wheel theft deterrent lock.
Installation Procedure
1. Install the steering wheel theft deterrent lock.
2. Route the wire harness assembly along the steering column jacket assembly.
3. Remove J 42640 from the steering column.
4. Install the wire harness assembly (1) into the wire harness strap (2).
