Corvette V8-7.0L (2007)
1. Install the transverse spring compressor J 33432-A to the transverse spring.
2. Install the transverse spring to the crossmember.
Notice: Do not remove the transverse leaf spring compressor tool until after the shock absorber has been installed. The pad on the transverse leaf
spring bolt could move out of position resulting in damage to the pad or a rattle in the suspension.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the transverse spring retainers and bolts (Use New Bolts) to the crossmember.
Tighten the transverse spring retainer bolts (Use New Bolts) to 62 N.m (46 lb ft).
4. Install the lower control arm to the front crossmember.
5. Install the cam bolts to the position that was marked during disassembly.
Due to a required wheel alignment, tighten the cam bolts but do not set to the final torque specification at this time.
Important: Use a new ball joint stud nut.
6. Install the lower control arm ball joint stud to the steering knuckle.
