Corvette V8-7.0L (2007)
Installation Procedure
Important: Inspect the TOC pipe fitting and retaining clip for signs of wear or damage. Replace the components if necessary.
1. Install the TOC pipe into the TOC pipe fitting.
A distinct snap should be heard or felt when assembling the TOC pipe to the fitting.
2. To ensure the cooler line is properly installed, give the cooler pipe a gentle pull.
Transmission Fluid Cooler Hose/Pipe Connector Replacement (Lower Radiator)
Transmission Fluid Cooler Hose/Pipe Connector Replacement (Lower Radiator)
Removal Procedure
Important: The transmission oil cooler in held into position inside the radiator by the transmission oil cooler (TOC) fittings.
Service one TOC fitting at a time. Removal of both TOC fittings will cause the cooler tank to fall out of position and require radiator
removal to install the TOC fittings.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Position a drain pan under the vehicle.
3. Disengage the plastic cap from the TOC fitting.
Pull the plastic cap back along the pipe.
4. Disconnect the TOC line from the TOC fitting.
5. Remove the TOC fitting from the radiator.
