Corvette V8-7.0L (2007)
Important: Only use NEW crossmember mounting nuts
18. Using HAND TOOLS ONLY, install NEW rear suspension crossmember mounting nuts (1).
Tighten the nuts to 110 N.m (81 lb ft).
19. Using HAND TOOLS ONLY, Install the nuts (2) securing the rear mounts to the suspension crossmember.
Tighten the lower differential mount nuts to 50 N.m (37 lb ft).
20. Connect the inner axle joints (1) to the differential.
21. Position an adjustable tall jack stand under the lower control arm near the ball joint location.
22. Raise the jack stand to reduce the transverse spring load on the lower control arm.
